This differs from Aluminum Standards and Data, which specifies wall thickness range as All. Remarks: In the case of AC7A, AC9A, and AC9B, the mechanical properties of test piece taken from the mould shown in Fig. Aluminum and Aluminum-Alloy Extruded Bars, Rods, Wire. Table 7 – Mechanical properties of permanent mould casting reference test pieces Intended to accept a standard sure-loc stake at a 45 degree angle to reduce edging movement and espe- cially soil shifts due to temperature changes. ![]() This reference contains: nominal and specified chemical compositions of alloys, typical mechanical and physical properties of commonly used commercial alloys mechanical property limits information on comparative characteristics and. However, this does not apply for elements used for modification or refinement processes. Aluminum Standards and Data is the preeminent reference for aluminum mill product standards and the most complete source of information on wrought aluminum. for individual elements and 0.15% in total. (1)a) Chemical components other than those given in the above table, including those shown in the table with “-” i.e., no specification values, shall be 0.05% max. ![]() Notes: Elements used for modification or refinement processes include Na, Sr, Sb, and P. Remarks: The elements not listed in Table 3 are analyzed only by the purchaser's request. Table 4 – Chemical Composition Unit: % Symbol
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |